GameSir K1 Kaleid D-Pad Replacement

Written By: Triniti Gutierrez
  • Comments: 0
GameSir K1 Kaleid D-Pad Replacement

Difficulty

Moderate

Steps

7

Time Required

15 - 20 minutes

Introduction

This guide will provide detailed step-by-step instructions on how to replace the D-pad for the GameSir K1 Kaleid wired controller. The D-pad is an input component that allows users to control the up, right, left, and down direction of movement within a game. Over time, continuous use of the D-pad can render it non-functional or begin sticking, crunching, missing inputs, incorrect inputs, or difficulty registering user presses.

  1. UeiJqBUkoFuB4UWt

    • Remove seven 1 mm screws from the backside of the controller using a TR6 Torx screwdriver.

    • There may be a screw covered under the manufacturer's sticker.

  2. RHhE4Mg6cBkrGyEI
    RHhE4Mg6cBkrGyEI
    VaXV4ErHEadwOsVE
    OGOYLuVcHyt6ZO5r

    • Hold the controller between your hands, with the front panel facing down.

    • Lift the back panel.

    • It should come up easily. If met with resistance, check for a missed screw on the back panel.

  3. r4Es3l4IFhKFHvvP
    r4Es3l4IFhKFHvvP
    CLxPKPJbesHFWgdY
    hgMGPET3j4qyGeJV

    • Hold the controller, grasp the rubber joystick cover, and pull upwards.

    • There will be resistance; pull firmly.

    • Repeat for the second joystick cover.

  4. XTqiLCrNyWh64QQl

    • Remove two 1 mm screws on either side of the power button using a TR6 Torx screwdriver.

  5. ihOipXQYV3qZdGnM
    ihOipXQYV3qZdGnM
    aN4jfRsDiq5qMxvb
    NMeBWDNCsfLcNXb5

    • Remove the power button and bumpers.

  6. ttLSpppWMLB3wiKw

    • Remove the four 1 mm screws on the daughterboard using a TR6 Torx screwdriver.

    • The screws are located above and below the D-pad and then to the left and to the southeast of the X, Y, A, B pad.

  7. XeyIQhBGT52LjFWm
    XeyIQhBGT52LjFWm
    MCZ44nAxqCpRtyIU
    PT6gIVU4FM16DNAV

    • Gently pull the daughterboard up from the front center and open it like a hinge to the left exposing the ribbon.

    • Use the iFixit opening tool or tweezers to lift the black clamp holding the ribbon in. Align the iFixit opening tool with the ribbon, gently push under the clamp, and then pop it upwards.

    • The ribbon can be removed from either the daughterboard or the motherboard below.

    • Replace this daughterboard to fix the D-pad function.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Triniti Gutierrez

Member since: 24/01/25

878 Reputation

0 comments