InFocus Screenplay 4805 Lamp Rebuild

Written By: Marilyn Urness
  • Comments: 0
InFocus Screenplay 4805 Lamp Rebuild

Difficulty

Moderate

Steps

3

Time Required

20 minutes

Introduction

This guide shows how to rebuild the projector lanp in your InFocus Scereenplay 4805 projector. You will need a replacement bulb and an iFixit tool kit.

  1. dDEg3EREk3OOMjUQ
    dDEg3EREk3OOMjUQ
    qhNDODZNTGChXdEW

    • This guide assumes tht you have removed the lamp unit from the projector. If you have not, refer to this guide first: InFocus Screenplay 4805 Lamp Replacement

    • Slide the bulb housing out of the projector.

    • Use the Phillips #1 screwdriver to remove the three 1 cm gold screws on the bulb housing.

  2. ShFDoAtbkAYYMuSS
    ShFDoAtbkAYYMuSS
    SG3XHpOysXnosKgH

    • This step is only required when rebuilding the old lamp with a replacement bulb.

    • Gently pull the top of the bulb housing off.

    • Lift up the middle of the bulb housing to remove it.

    • Be careful of loose parts, such as the metal housing and the glass focusing lens.

  3. 1tvjMQ4VjGWFZmPH
    1tvjMQ4VjGWFZmPH
    66B5AM1SBOoVOUUJ
    IiqhSsiMa5WYwF2j

    • This step is only required when rebuilding the old lamp with a replacement bulb.

    • Unhook the spring from the bulb housing.

    • Gently remove the bulb.

Conclusion

To reassemble the device, follow these instructions in reverse order.

Author

Marilyn Urness

Member since: 28/09/17

671 Reputation

0 comments