Razer Kishi V2 Pro D-Pad Replacement

Written By: Epiphany Johnson
  • Comments: 0
Razer Kishi V2 Pro D-Pad Replacement

Difficulty

Easy

Steps

3

Time Required

1 minute

Introduction

This is a guide on replacing the D-pad on the Razor Kishi v2 Pro. This guide will walk you through the simple process of replacing it. With easy-to-follow steps, you’ll have your controller's D-pad restored to its original condition and ready for smooth, precise gameplay. Let’s get started and bring your Razor Kishi V2 Pro back to life!

  1. LR6HAc5s3WD3eqCi

    • Put the device down with the bottom facing up.

    • Remove the eight 12 mm screws from the back of the controller using a T5 screwdriver.

  2. nRM25ZcHASjO1JKy
    nRM25ZcHASjO1JKy
    k1u3XPjTsPr2LUfi
    QONPQZ53ZOrywUip

    • Gently apply light pressure to the front top half of the controller and slowly lift it up.

    • When you hear a click, the two halves should be successfully disconnected.

    • When you separate the two parts from each other, two of the back bumpers might fall out. If the bumpers do fall out don't worry because they just snap back in.

    • Be careful when doing this, if you apply too much pressure you could rip the ribbon cable.

    • Repeat for the opposite side of the controller.

  3. MEgRlSUBKGoHYfUD
    MEgRlSUBKGoHYfUD
    jNwdjNvE4EuNySsD

    • Using tweezers or your fingers, remove the D-pad from the silicone pad.

    • Make sure not to pull out the silicone pad.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Epiphany Johnson

Member since: 07/02/25

76 Reputation

0 comments