Razer Kishi v2 Pro Front Panel Replacement

Written By: Sean Chichurka
  • Comments: 0
Razer Kishi v2 Pro Front Panel Replacement

Difficulty

Very easy

Steps

2

Time Required

1 minute

Introduction

This is a guide on how to take off the Razer Kishi v2 pro Front panel. Use this guide as a prerequisite for all other replacement guides related to this device.

  1. LR6HAc5s3WD3eqCi

    • Put the device down with the bottom facing up.

    • Remove the eight 12 mm screws from the back of the controller using a T5 screwdriver.

  2. nRM25ZcHASjO1JKy
    nRM25ZcHASjO1JKy
    k1u3XPjTsPr2LUfi
    QONPQZ53ZOrywUip

    • Gently apply light pressure to the front top half of the controller and slowly lift it up.

    • When you hear a click, the two halves should be successfully disconnected.

    • When you separate the two parts from each other, two of the back bumpers might fall out. If the bumpers do fall out don't worry because they just snap back in.

    • Be careful when doing this, if you apply too much pressure you could rip the ribbon cable.

    • Repeat for the opposite side of the controller.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sean Chichurka

Member since: 08/02/25

193 Reputation

0 comments