0

I tried building the application and run it. Got an error. So decided to debug it. But when i place the debug point, it's not working.

Scrrenshot

dymanoid
  • 14,771
  • 4
  • 36
  • 64
Jimmy Mathew
  • 1
  • 7
    Usually the breakpoint not being enabled either means that you're not running in Debug mode, the code isn't running in the application, or you're running an outdated version of the code. Solution: Ensure you're using the Debug configuration, and then clean & rebuild. – ProgrammingLlama May 07 '18 at 07:54
  • 2
    Make sure, your method is is reachable / called. – FrankM May 07 '18 at 07:57
  • 3
    If you hover over that break point during run-time it should also tell you why it wont break there. – Neijwiert May 07 '18 at 08:01
  • 2
    Cn you place breakpoints anywhere in the code? – TaW May 07 '18 at 08:36
  • When I hover over the breakpoint, I get the following message. "The breakpoint will not currently be hit.No Symbols have been loaded for this document." – Jimmy Mathew May 07 '18 at 09:00
  • There are many possible reasons for this error and this question has been asked many times in SO. I recommend to read the answers [here](https://stackoverflow.com/questions/2155930/how-do-i-remedy-the-the-breakpoint-will-not-currently-be-hit-no-symbols-have-b). – Tomas May 07 '18 at 14:11
  • That was the first page which popped up when i was searching for the solution. I tried every solution and nothing worked for me. It's still the same. That's why i decided to post it as a separate question. – Jimmy Mathew May 08 '18 at 05:14

0 Answers0