0

I have the following file names where I am trying to relabel v5.4b to v5.7:

v5.4b_lvl-1.e8974326
v5.4b_lvl-1.o8974326
v5.4b_lvl-1.pe8974326
v5.4b_lvl-1.po8974326
v5.4b_lvl-2.1.e8974303
v5.4b_lvl-2.1.o8974303
v5.4b_lvl-2.1.pe8974303
v5.4b_lvl-2.1.po8974303
v5.4b_lvl-2.2.e8974304
v5.4b_lvl-2.2.o8974304
v5.4b_lvl-2.2.pe8974304
v5.4b_lvl-2.2.po8974304
v5.4b_lvl-3.1.e8974305
v5.4b_lvl-3.1.o8974305
v5.4b_lvl-3.1.pe8974305
v5.4b_lvl-3.1.po8974305
v5.4b_lvl-4.1.e8974327
v5.4b_lvl-4.1.o8974327
v5.4b_lvl-4.1.pe8974327
v5.4b_lvl-4.1.po8974327

I can't do mv v5.4b_* v5.7_* because it thinks v5.7_* is a directory so I am trying a for-loop but I can't get it to work

I am trying the recommended answer from this SO post How to set a variable to the output of a command in Bash? but getting a bunch of empty lines.

What am I doing incorrectly? How can I save the output of cut to SUFFIX so I can mv $i v5.7_$SUFFIX? 

-bash-4.1$ for i in v5.4b*; do echo $i | SUFFIX=`cut -f2 -d'_'`; echo ${SUFFIX}; done
O.rka
  • 29,847
  • 68
  • 194
  • 309

2 Answers2

2

You've got echo $i in the wrong place. The output of that command needs to be piped to cut for it to read anything, then the result is assigned to SUFFIX:

for i in v5.4b*
do 
    SUFFIX=`echo $i | cut -f2 -d'_'`
    echo ${SUFFIX}
done
dbush
  • 205,898
  • 23
  • 218
  • 273
  • `for i in v5.4b*; do SUFFIX=`echo $i | cut -f2 -d'_'`; mv $i v5.7_${SUFFIX}; done` NICE thanks – O.rka Jun 11 '18 at 19:31
1

If you rename utility then just do:

rename -n 's/v5\4.b/v5.7/' v5.4b*

PS: -n is for dry-run. You may remove it later for real renaming.

If rename is not available then use:

for i in v5.4b*; do
   echo mv "$i" "${i/v5.4b/v5.7}"
done

Remove 'echo` if you're satisfied with the output.

anubhava
  • 761,203
  • 64
  • 569
  • 643
  • I'm definitely going to use this in the future. I had to mark the other one as correct since that was specific to the questino but thanks a lot for sharing this. I upvoted. – O.rka Jun 11 '18 at 19:50