4

I run a WiFi hotspot from my Windows 8.1 PC (Windows 10 Technical preview from last few days). When I try to connect from my android, the signal strength goes low and then results in authentication problem.

But after or before that, i.e. when the WiFi access point is only listed, it shows excellent signal strength.

Why does it happen so, or is there a remedy for that ?

OS: Windows Technical Preview x64
Drivers:
Broadcom 802.11n Network Adapter (HWID : PCI\VEN_14E4&DEV_4727&SUBSYS_1795103C&REV_01)
Realtek PCIe FE Family Controller (HWID: PCI\VEN_10EC&DEV_8136&SUBSYS_1670103C&REV_05)
Don't know what/how to list Please Check this result from Driver Identifier

Hotspot created by Virtual Router manager
Client device: Micromax Canvas A1
Note: I previously used a Nokia 500 device which used to connect to my WiFi hotspot successfully. And as for my android, it can connect to other hotspots.

MAKZ
  • 1,447

1 Answers1

0

The transmit power of an AP changes based on its data rate. In other words, lower data rates have a longer range. I've noticed this behavior myself, and I'm not the only one.

It sounds like you're either on the fringe of your AP's range and/or your device is doing a poor job negotiating a connection speed. For the former, move closer to the AP or use better or additional APs. For the later, update the firmware of the APs and update the WLAN drivers for the devices.

Jason
  • 8,203