Medical Machines/Microtomes/Replace cowling

← Replace barrel-cylinder assembly ↑ Microtomes Replace cylinder head, chuck and knife →

Replacing the cowling

  • 1. Set the middle cover in place.
    1. Set the middle cover in place.
  • 2. Set the right cover in place.
    2. Set the right cover in place.
  • 3. Replace the section thickness knob. The shaft is held in the dial by a spring loaded ball.
    3. Replace the section thickness knob. The shaft is held in the dial by a spring loaded ball.
  • 4. Support the right side of the machine.
    4. Support the right side of the machine.
  • 5. Replace the M5 x 16 mm screw with star washer fastening the middle cover at the right front corner.
    5. Replace the M5 x 16 mm screw with star washer fastening the middle cover at the right front corner.
  • 6. Replace the M5 x 16 mm screw with star washer fastening the side cover at the front of the machine.
    6. Replace the M5 x 16 mm screw with star washer fastening the side cover at the front of the machine.
  • 7. Replace the M5 x 16 mm screw with star washer fastening the middle cover at the right rear corner.
    7. Replace the M5 x 16 mm screw with star washer fastening the middle cover at the right rear corner.
  • 8. Replace the M5 x 16 mm screw with star washer fastening the side cover at the rear of the machine.
    8. Replace the M5 x 16 mm screw with star washer fastening the side cover at the rear of the machine.
  • 9. Rotate the chassis and replace the left cover.
    9. Rotate the chassis and replace the left cover.
  • 10. Support the left side of the machine to reach four M5 screws.
    10. Support the left side of the machine to reach four M5 screws.
  • 11. As on right side, replace the screw fastening the middle cover at the left front corner.
    11. As on right side, replace the screw fastening the middle cover at the left front corner.
  • 12. Replace the screw fastening the side cover at the front of the machine.
    12. Replace the screw fastening the side cover at the front of the machine.
  • 13. Replace the screw fastening the middle cover at the left rear corner.
    13. Replace the screw fastening the middle cover at the left rear corner.
  • 14. Replace the screw fastening the side cover at the rear of the machine.
    14. Replace the screw fastening the side cover at the rear of the machine.
  • 15. Remove the support block.
    15. Remove the support block.
← Replace barrel-cylinder assembly ↑ Microtomes Replace cylinder head, chuck and knife →
This article is issued from Wikibooks. The text is available under Creative Commons Attribution-Share Alike 4.0 unless otherwise noted. Additional terms may apply for the media files.