I have followed these instructions on my Windows 10 PC:
1) Go to Control Panel/Programs and Features/Turn Windows Features on and Off
2) 'Hyperv' and 'Windows Hypervisor Platform' are enabled. Therefore I disable them by unticking the two checkboxes.
3) Click ok.
4) At this point I expect to see a message saying success (please restart your PC). Instead I see this:
After I click close and then restart my PC. After this I notice the two settings are still enabled. What is the problem?
I have Hyper-V and Windows Hypervisor Platform installed as shown below:
I can disable one or the other but not both. If I attempt to disable both (either at the same time or one after the other (restarting in between) then I see the error in point four above).
Here is what I see when I am troubleshooting:
