Medical Machines/Microtomes/Replace cylinder in barrel

← Adjust clutch between cylinder and nut ↑ Microtomes Replace barrel-cylinder assembly in sliding block →

Replace cylinder in barrel

  • 1. Thread the micrometer spindle back into the nut in the cylinder.
    1. Thread the micrometer spindle back into the nut in the cylinder.
  • 2. Carefully insert the cylinder into the barrel.
    2. Carefully insert the cylinder into the barrel.
  • 3. Replace the four M4 x 12 mm screws fastening the bearing disk to the end of the barrel.
    3. Replace the four M4 x 12 mm screws fastening the bearing disk to the end of the barrel.
  • 4. Replace the gear wheel assembly. Two M3 x 16 mm screws with lockwashers fasten it.
    4. Replace the gear wheel assembly. Two M3 x 16 mm screws with lockwashers fasten it.
  • 5. Replace the pinion and the two bearing blocks fastened by four M4 x 25 mm screws.
    5. Replace the pinion and the two bearing blocks fastened by four M4 x 25 mm screws.
← Adjust clutch between cylinder and nut ↑ Microtomes Replace barrel-cylinder assembly in sliding block →
This article is issued from Wikibooks. The text is available under Creative Commons Attribution-Share Alike 4.0 unless otherwise noted. Additional terms may apply for the media files.